Sunday, September 9, 2012

I Interrupt this Dress with Pillowcases!

Yes, I needed a change of pace - a quick-er pick-er up-per.

I had already bought these fabrics just for making pillowcases - except for the fabric left over from my dress (upper left fabric):

So far, I have finished the white pillowcase liners, shown underneath at the right, and the red print pillowcases.  Since this fabric has printing along one edge, I sewed the pillowcases with the printing at the opposite end from the hem so I could cut off the words:

This is my quick version of pillowcases.  I use the full width of the fabric, preferably in the 42- to 45-inch range.  I always buy 1-1/4 yards of woven cotton fabric for each pillowcase and prewash (washer and dryer) three times before cutting it out.  I cut across one end to even the fabric. The liner fabric is shown here with the big ruler ready for the cut:

First I measure 21" from the trimmed edge:

Then I roll up the fabric, skootch it across the cutting mat, and cut another 21" beyond that, for a total length of 42".

Note: When making pillowcase liners, the second cut is 20" for a total length of 41". This tutorial was originally written before I started to make the outer pillowcases bigger.

Here are all my printed fabrics on the ironing board, ready for the next step:

I used a selvage for the hems of the printed fabrics, but the white fabric had two unfinished selvages.  I serge-finished one edge of the liners for the hem.

The fabrics were folded crossways, which folded each selvage in half.  A pin was placed three inches from the selvage at the cut edge ...

... and at the folded edge:

I used the pins to fold the hem down:

I pinned all along the cut edge:

Here is a pile of pillowcases ready to be stitched:

I stitched them together on the serger, making it a quick project.  I started at the hem, leaving a thread tail:

I stitched down the length of the pillowcase, angled in a bit at the end, and stitched off the fabric.  I then stitched across the end of the pillowcase, crossing the previous stitching at the side, and tapering in at both ends of that stitching.  This tapers in the corners just a little bit.  This is when the printed selvages were cut off:

I used a double-eyed needle to tuck in the thread tails.  At the hem, I weave the needle between the hem and the pillowcase, pointing it towards the fold of the hem, and then out:

Once the needle is in place, I thread the tails into the needle and pull it back out.

When the thread tails are too long, I trim them.

Next, I steam press all the stitching, and then I pin and press the three-inch hem in place:

I stitched the hems in place along the selvage edges using my sewing machine:

Here is the end result:

4 comments:

  1. What a lovely way to freshen up a room- those look great!

    ReplyDelete
    Replies
    1. Yeah, they are "different!" It could have been a dress, but I already have enough red in my wardrobe - trying to balance it now with the blue side of the color wheel!

      Delete
  2. I love your pillowslips! Where do you find a double-eye needle? I tie my thread ends back in all the time at the end of pockets and topstitching, but it takes more time with only one eye!

    ReplyDelete
    Replies
    1. I probably bought the double-eyed needle at Nancy's Notions. I just looked, and she still sells them.

      Delete

If you would like to be notified by email when someone replies to your comment, please click the "Subscribe by email" link under this comment box.